SD9088W Capacitor Flame Retardant Sealant 2.6L

Brand: SANDAO

MOQ: 10 Pieces

Delivery time: 15 Day

Characteristics: This product is a single component demethanol type silicone compound, white paste. Acid and alkali resistance, aging resistance, corrosion resistance, radiation resistance and good weather resistance, can be used at-60~260℃. The product has good electrical insulation performance and bonding performance, and can fully meet the bonding requirements of electronic components.

Product Details

◆Product model: SD9088W single component room temperature sulfide silicone rubber

◆Characteristics: This product is a single component demethanol type silicone compound, white paste. Acid and alkali resistance, aging resistance, corrosion resistance, radiation resistance and good weather resistance, can be used at-60~260℃. The product has good electrical insulation performance and bonding performance, and can fully meet the bonding requirements of electronic components.

◆Environmental requirements: comply with RoHS Directive and relevant environmental requirements

■Appliance

Applied to the bonding and filling between electronic and electrical products. The bonding and filling between the circuit substrate and other materials has excellent bonding properties and no corrosion to copper and PC (polycarbonate)■Electrical / mechanical properties(At TA=25℃)

parameter	symbol	testing standard	performance index
Hardness shore A	HA	GB/T 531.1	60±5
Elongation %	δ	GB/T 528	≥150
tensile strength MPa	Rm	GB/T 528	≥1.5
shear strength MPa	σc	GB/T 7124	≥1.5
dielectric strength kV/mm	eo	GB/T 1695	≥15
dielectric constant 1.0MHz	ε	GB/T 1693	3.0
mass resistivity Ω·cm	ρ	GB/T 1692	≥1.0×10¹³
Linear contraction rate %	r	HG/T 2625	≤0.6
breakdown strength kV/mm	/	GB/T 1695	≥15
Communication pressure resistance kV	/	ASTM D149	≥20

■ absolute rating (At TA=25℃)

parameter	symbol	numerical value	unit
Table dry time	TFT	≤30	min
curing time	TFT	≤24	H
proportion	s.g.	1.7±0.1	g/cm³
proportion	V	V-0	UL-94
working temperature	T_OPR	-60°C To +260°C
storage temperature	T_STG	10°C To +25°C

■Use method and matters needing attention

※Clean the adhesive seal surface and place the top of the tip according to the dosage Cut off the seal, put it on the packaging mouth, and paint it on the construction surface (thickness More than 6mm), placed in air, this product room temperature for 10-30 minutes surface Can lose the sticky type (table dry), 24 hours after the complete curing, this product heating The curing speed cannot be significantly changed.

※The unused adhesive should be sealed and stored. When used again, if there is a little skin at the seal, it can be removed and does not affect the normal use. During the storage process, there may also be a small amount of curing at the nozzle, which can be used normally after removal without affecting the performance of the product. The storage period is 6 months (25℃).

※This product is a non-dangerous goods, but do not enter and eyes.

※This product can not be mixed with other types of colloid!