Home Products Water-based glue and solvent glue

SD3000 Line board protection paint

Brand: SANDAO

MOQ: 10 Pieces

Delivery time: 15 Day

◆ Characteristics: protective paint (commonly known as three waterproof) is a low viscosity room temperature curing single component product, easy to soak, brush, spraying, with good high and low temperature resistance (-20~ + 100 C) and excellent electrical insulation performance, aging resistance, moisture-proof, dust proof, prevent harmful gas performance. Suitable for the indoor protection of PCB circuit board and electronic components. ◆ Environmental protection requirements: meet the RoHS directive and related environmental protection requirements

Product Details

◆ Product model: SD3000 Circuit board protective paint

◆ Environmental requirements: comply with RoHS directive and relevant environmental requirements

◆ References standard: Q / 4413SD004-2021 circuit board protective paint series

■Appliance

Mainly used in all kinds of electronic components, instruments, machinery, stone bonding, sealing and coating.

■Electrical / mechanical properties(At TA=25℃、RH：50%)

status	inspecting item	testing standard	bear fruit
bear fruit	pigment	---	transparent
	dynamic viscosity mPaS mPa·S	GB/T 10247	400～800
	Density g/cm³	GB/T 13354	0.75～0.85
	Table dry time min	GB/ T134775	25～40
firm spend behind	Hardness ShoreA	GB/T 531.1	15～25
	tensile yield %	GB/T 528	＞100
	tensile strength MPa	GB/T 528	0.35
	tensile strength Kv/mm	GB/T 1693	≥18
	tensile strength Mpa	GB/T 6328	≥0.8
	volume resistivity Ω cm	GB/T 1692	5.0×10¹⁴

Note: The curing data of the above products are 25 C, 50 ± 5% relative humidity, and obtained after 7 days of curing.

■Use method and matters needing attention

※Baptist process:

①Pour the protective paint into the immersion bucket and apply it. The immersion speed of the circuit board or components should not be too fast to avoid generating bubbles. After soaking, hanging and hanging, the normal temperature meter dry time is not longer than 40 minutes, as far as possible without heating and drying.

②After the coating, if there is any remaining protective paint, return the empty container, Keep sealed and use up as quickly as possible; when again, if The surface crust removes the epidermis without affecting the performance of the product, Can continue to use.

※Spray process:

①Dilute the protective paint with a special diluent, add a large amount of diluent, The viscosity of glue is low and the thickness of glue is thin; otherwise, the viscosity of glue is high The thickness of the glue is thick. The amount of diluent is recommended to be 10 to 20%.

②Apply the diluted glue into a spray can.

③After the spraying, clean the watering can with the thinner.

※After pouring out the glue in the container, wipe the glue at the mouth of the bottle and tighten the bottle Cover, sealed in a cool place. When used again, if there is a little at the mouth of the bottle Skin, it can be removed, does not affect the normal use.

※This product is a non-dangerous goods, but do not enter and eyes.