S-3911 LED light bulb does not white fog waterproof adhesive 2.6L

Brand: SANDAO

MOQ: 10 Pieces

Delivery time: 15 Day

This product is a fast drying neutral silicone adhesive, no fog, no white, no solvent, no corrosion, no pollution, at room temperature contact moisture curing, paste does not flow. It has excellent moisture resistance, aging resistance and electrical insulation properties, the adhesive material has good adhesion to metals and most plastics, and has excellent cold and heat resistance after curing (-50-250℃).

Product Details

◆ Product model: S-3911Single component LED light no fog no white waterproof adhesive

◆ product description：Used for LED guardrail tube, LED point light source and other lighting engineering plastic, metal, glass bonding seal, also used for electronic circuit board on the electronic components bonding positioning and fixing

◆ product feature：This product is a fast drying neutral silicone adhesive, no fog, no white, no solvent, no corrosion, no pollution, at room temperature contact moisture curing, paste does not flow. It has excellent moisture resistance, aging resistance and electrical insulation properties, the adhesive material has good adhesion to metals and most plastics, and has excellent cold and heat resistance after curing (-50-250℃).

■Technical parameter

Test item	S-3911BT
appearance	Translucent fluid
shear strength（mpa.s）	(2.0-4.0)×10⁴
Specific gravity(g/ml)	1.0-1.2
Surface drying time min 25℃RH：60%	≤8
hardness(JISA)	≥35
elongation (%)	≥150
Tensile strength(MPa)	≥2.5
Shear strength(MPa)	≥2.0
Volume resistivity (Ω.cm)	2.0×10¹⁴
Dielectric strength (kv/mm)	≥20
Dielectric constant (1.2MHz)	2.8
Loss factor (1.2MHz)	0.001
Linear shrinkage rate（%）	≤0.6
Full curing time（h）	24

The above properties were measured at 25℃ and 7 days after full curing. HongongThe company is not responsible for the different data caused by different test conditions or product improvement

■ Packaging, storage and transportation requirements Packaging with aluminum leather tube or plastic tube, with 100ml aluminum pipe and 300mlPE pipe, this product should be stored in a dry and cool place (below 26℃). The shelf life of this product is within 6 months from the manufacturing date.

■ Usage and precautions First clean the bonded sealing surface, and then apply this product on the surface (the thickness should not exceed 6mm). The drying time of this product is less than 15 minutes, and the complete curing is achieved after 24 hours. After the operation, the unused glue shall be tightened immediately and sealed. When used again, if there is a little skin at the seal, it can be removed, do not affect the normal use. In the storage process, there may also be a small amount of curing at the nozzle, which can be used normally after removal without affecting the performance of the product.